Konica Minolta Fujitsu fi-6400 Operation Guide - Page 100
Replacing the Brake Roller
View all Konica Minolta Fujitsu fi-6400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 100 highlights
Chapter 6 Replacing Consumables 6.4 Replacing the Brake Roller 1 Remove all documents from the stacker. 2 If the hopper has been raised, bring it back down to the lower position. For information on how to adjust the hopper level, refer to "1.7 Setting the Loading Capacity of the Hopper" (page 22). 3 Open the ADF. For information on how to open the ADF, refer to "1.5 Opening/ Closing the ADF" (page 19). Be careful not to have your fingers caught when the ADF closes. 4 Remove the brake roller from the scanner. 1 Open the roller cover. Lift up the cover from the lower middle. Roller Cover 2 Remove the brake roller. Lift the left side of the roller first, then pull out the shaft from left to right. TOP Contents Index Introduction Scanner Overview 1 2 Brake Roller How to Load Documents How to Use the Operator Panel Various Ways to Scan 5 Install a new brake roller on the scanner. 1 Install the brake roller. Insert the shaft from the right side to the left. 2 Daily Care Replacing Consumables Troubleshooting 1 Brake Roller 2 Close the roller cover. Make sure that both ends of the cover are locked firmly. Operational Settings Appendix Glossary 100