Konica Minolta Fujitsu fi-6400 Operation Guide - Page 180
Settings Related to Maintenance/Options
View all Konica Minolta Fujitsu fi-6400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 180 highlights
Chapter 8 Operational Settings 8.8 Settings Related to Maintenance/Options Setting the Maintenance/Inspection Cycles for the Scanner [Maintenance and Inspection Cycle] 2 From the listing on the left, click [Device Setting 2] [Maintenance and Inspection Cycle]. You can specify the cycle of regular maintenance/inspection by a service engineer. A message for regular maintenance appears when the time specified here elapses after the last time regular maintenance/ inspection was performed. Messages for regular maintenance can be checked in [Information] of the operator panel. 1 Start up the Software Operation Panel. Refer to "8.1 Starting Up the Software Operation Panel" (page 132). 3 Select whether to enable or disable [Maintenance and Inspection Cycle]. When you enable this setting, select a cycle for maintenance/ inspection by a service engineer. TOP Contents Index Introduction Scanner Overview How to Load Documents How to Use the Operator Panel Various Ways to Scan Daily Care Replacing Consumables Troubleshooting Operational Settings Appendix Glossary 180