Konica Minolta Fujitsu fi-6400 Operation Guide - Page 124

Chapter 7 Troubleshooting Situation in which the document is not fed into the ADF occur frequently. Does the condition of the documents fulfill the requirements described in "Precautions" in "Paper Quality" (page 37)? Yes Did you fan the documents before loading them on the hopper? Yes Are the consumables (*1) installed correctly? Yes Are any of the consumables (*1) dirty? No Are any of the consumables (*1) worn out? Use a document that satisfies the required conditions. For more details, refer to "2.2 Documents for Scanning" (page 37). No Fan the documents before loading, or reduce the amount of sheets. No Install the consumables (*1) correctly. For information on how to install the consumables, refer to "Chapter 6 Replacing No Consumables" (page 93). Clean the consumables (*1). For more details, refer to "5.2 Cleaning the ADF (with Cleaning Sheet)" (page 84) Yes or "5.3 Cleaning the ADF (with cloth)" (page 86) Check the Consumables Counter. Replace the consumables if necessary. For information on how to replace the consumables, refer to "Chapter 6 Replacing Yes Consumables" (page 93). No If the above countermeasures do not solve the problem, check the items in "7.4 Before You Contact the Scanner Service Provider" (page 128) first, then contact your FUJITSU scanner dealer or an authorized FUJITSU scanner service provider. *1: "Consumables" refers to the pick roller, separator roller and brake roller. TOP Contents Index Introduction Scanner Overview How to Load Documents How to Use the Operator Panel Various Ways to Scan Daily Care Replacing Consumables Troubleshooting Operational Settings Appendix Glossary 124