Konica Minolta Fujitsu fi-6400 Operation Guide - Page 151

Chapter 8 Operational Settings Eliminating Shadows or Streaks on the Scanned Image Edge [Page Edge Filler (ADF)] Depending on the condition of the document that you scan, some shadow of the document may be reflected onto the edge of the output image and appear as black streaks. In this case, you can improve the image quality around the edges by using the Page Edge Filler function to fill around the edges. 1 Start up the Software Operation Panel. Refer to "8.1 Starting Up the Software Operation Panel" (page 132). 2 From the listing on the left, select [Device Setting 2]  [Page Edge Filler (ADF)]. 3 Specify the width of each margin to fill: top, bottom, right, and left. T T :Top = 0 to 15 mm B :Bottom= -7 to 7 mm R :Right = 0 to 15 mm L Image R L :Left = 0 to 15 mm area (in 1 mm increments) B The specified area is filled in the same color as the background. Note that if the target range of the Page Edge Filler is too wide, some characters near the edge may be cut out.  The background is normally white but it can be changed to "Black background" in the scanner driver. If you are using the TWAIN scanner driver, select the [Option] button, and then specify [Black background] for [Automatic Size and Skew detection] in the [Rotation] tab.  This setting can also be configured from the scanner driver's setup dialog box. Note that priority is given to the setting with the larger value.  This setting does NOT appear when Kofax VRS (optional) is used. TOP Contents Index Introduction Scanner Overview How to Load Documents How to Use the Operator Panel Various Ways to Scan Daily Care Replacing Consumables Troubleshooting Operational Settings Appendix Glossary 151