Konica Minolta Fujitsu fi-6400 Operation Guide - Page 144

Chapter 8 Operational Settings Item Description Setting/Value Factory Default SCSI or USB VRS board (optional) Connector connection : Configurable -: Not configurable Scan Setting for Document in Dark Background Color Configure this setting when the edges of a document with dark background color are falsely detected. You can specify the level of sensitivity to accurately detect the edges of documents with dark backgrounds. Enable / Disable Disable Density of background color: Level 1 to 5 -  Overcrop/ Undercrop Adjust the size of the scanned document output image detected in Automatic Page Size Detection. Overcrop: 0 to 5 mm (in increments of 1 mm) Undercrop: -5 to 0 mm (in increments of 1 mm) 0 mm -  Maintenance and Inspection Cycle Specify the cycle for scanner maintenance and inspection to be performed by a service engineer. When the specified time period elapses since the last periodical maintenance and inspection, a message for periodical maintenance appears. Disable / Enable Maintenance/Inspection cycle: 1 to 12 months Disable   Multi dropout colors Specify a color to be dropped out from the scanned image (black & white/grayscale mode only). You can select any color(s) to drop out in [Multi dropout colors]. Note that priority is given to the scanner driver setting if any dropout color has been specified in the scanner driver's setup dialog box. Use driver settings / Custom Use driver settings -  Overscan Control Outputs the image in the optimum position when the image is partially missing due to a large skew. Normal / Optimize Black frame thickness: Thin (Default) to Thick (level 1 to 3) Normal  - TOP Contents Index Introduction Scanner Overview How to Load Documents How to Use the Operator Panel Various Ways to Scan Daily Care Replacing Consumables Troubleshooting Operational Settings Appendix Glossary 144