Konica Minolta Fujitsu fi-6400 Operation Guide - Page 178
Setting the Waiting Time to Enter Power Saving Mode [Power saving
View all Konica Minolta Fujitsu fi-6400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 178 highlights
Chapter 8 Operational Settings Setting the Waiting Time to Enter Power Saving Mode [Power saving] When the scanner is not being used for a certain period of time, it enters power saving mode to save the power consumption. 1 Start up the Software Operation Panel. Refer to "8.1 Starting Up the Software Operation Panel" (page 132). 2 From the listing on the left, select [Device Setting]. 3 Use the slide bar to specify the waiting time to enter power saving mode. It can be set in the range of 5 to 235 minutes (in increments of 5 minutes). When you select the [Power off after a certain period of time] check box, the scanner will turn itself off automatically if it is turned on and left unused for the set time. The time until power-off can be selected from 1/2/4/ 8 hours. TOP Contents Index Introduction Scanner Overview How to Load Documents How to Use the Operator Panel Various Ways to Scan Daily Care Replacing Consumables Troubleshooting Operational Settings Appendix Glossary 178