Konica Minolta Fujitsu fi-6400 Operation Guide - Page 89

Scan Glass, Glass removable, Cross- Glass

Get Konica Minolta Fujitsu fi-6400 PDF manuals and user guides View all Konica Minolta Fujitsu fi-6400 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 89 highlights

Chapter 5 Daily Care Scan Glass Clean it lightly.  Paper path upper-side (glasses: 2 sheets) Glass (removable) Glass (not removable) The glass should not have to be removed as it is designed to block paper dust. Remove and clean the glass only if the scanner is being used in an environment with large amounts of paper dust and vertical streaks appear on the scanned image even after cleaning the glass. Be careful not to let any paper dust in when removing the glass. Clean the glass on paper path upper-side as follows: 1 3 2 1 Loosen the screw until the glass can be lifted. 2 Tilt the glass to the angle as shown above. 3 Remove the glass as you slide it to the right. 4 Clean the removed glass. 5 From the gap where the glass was attached, clean the other layer of glass inside, using a cotton swab or something alike. Glass Cross-section TOP Contents Index Introduction Scanner Overview How to Load Documents How to Use the Operator Panel Various Ways to Scan Vertical streaks may appear on the scanned image when the glass is dirty. Daily Care Replacing Consumables Troubleshooting Operational Settings Appendix Glossary 89

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
  • 200
  • 201
  • 202
  • 203
  • 204
  • 205
  • 206
Index
Chapter 5 Daily Care
Appendix
Glossary
Introduction
Contents
TOP
89
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Troubleshooting
Replacing
Consumables
Scanner
Overview
Daily Care
Operational
Settings
Scan Glass
Clean it lightly.
Paper path upper-side (glasses: 2 sheets)
The glass should not have to be removed as it is designed
to block paper dust. Remove and clean the glass only if
the scanner is being used in an environment with large
amounts of paper dust and vertical streaks appear on the
scanned image even after cleaning the glass. Be careful
not to let any paper dust in when removing the glass.
Clean the glass on paper path upper-side as follows:
1
Loosen the screw until the glass can be lifted.
2
Tilt the glass to the angle as shown above.
3
Remove the glass as you slide it to the right.
Glass (removable)
Glass (not removable)
2
1
3
4
Clean the removed glass.
5
From the gap where the glass was attached, clean
the other layer of glass inside, using a cotton swab or
something alike.
Vertical streaks may appear on the scanned image when
the glass is dirty.
Cross-section
Glass