Konica Minolta Fujitsu fi-6400 Operation Guide - Page 56

Chapter 3 How to Use the Operator Panel 6 Load the documents on the hopper, start up a scanning application, and perform a scan.  Depending on the number of sheets scanned, it will be displayed as follows: Sheets Display Description 75 sheets Since the count has been set to 100 in step 4, it is -25 sheets. [-] appears in the top right and [Count] indicates "25". If you load additional documents at this point, you can scan up to 25 sheets. 100 sheets Since the count has been set to 100 in step 4, it is +/- 0. [=] appears in the top right and [Count] indicates "0". 110 sheets Since the count has been set to 100 in step 4, it is +10 sheets. [+] appears in the top right and [Count] indicates "0". Scanning stops once 100 sheets have been scanned.  Documents may not be counted correctly if a multifeed occurs during scanning.  In the following cases, the scanning returns to normal from Doc Count Check mode: - When you only scan the specified pages - When you scan using a Job Separator  When you press the [Counter Reset] button, the screen returns to [Doc Count Check Mode] in step 5.  When you press the [Stop] button, it exits [Doc Count Check Mode] and returns to the [Ready] screen. TOP Contents Index Introduction Scanner Overview How to Load Documents How to Use the Operator Panel Various Ways to Scan Daily Care Replacing Consumables Troubleshooting Operational Settings Appendix Glossary 56