Kyocera FS-C5350DN FS-C5350DN Operation Guide (Advanced) - Page 106
Password Administrator Password input, Change ID Administrator ID change
View all Kyocera FS-C5350DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
Password _ >Change ID 00000001 >Change ID 001 >Change ID _ OK? 002 Password (Administrator Password input) You can use this to set the administrator password. Note The default setting is "3000". 1 Once you have entered the correct ID in the previous step (ID (Administrator ID input)), the message display shows Password (Administrator password input) and a blinking cursor (_). 2 Press U or V to increase or decrease, respectively, the value at the blinking cursor. Enter the specified password. Use Y and Z to move the cursor right and left. Enter a password consisting of between 0 and 16 numbers. Note If you enter the incorrect administrator ID or password, the Wrong ID or Wrong Password message appears and the input screen then reappears. Re-enter the ID or password correctly. 3 Once you enter the correct ID and password, the Admin (change) screen appears. (E.g.: Where the administrator ID is 00000001) Each time you press U or V, the following settings to be changed appear in succession. • Change ID • Change Password Note If a change is required, refer to the procedures in Change ID (Administrator ID change) and Change Password (Administrator Password change) below. 4 Press [OK] again. The administrator ID and password are confirmed. 5 Press [MENU]. The display returns to Ready. Change ID (Administrator ID change) You can use this to change the administrator ID. 1 In step 3 in Password (Administrator Password input) above, press U or V while the Admin (Change) screen is displayed until >Change ID appears. (E.g.: Where the administrator ID is 001) 2 When you press [OK], a blinking cursor (_) appears. 3 Press U or V to increase or decrease, respectively, the value at the blinking cursor. Enter the ID to be changed. Use Y and Z to move the cursor right and left. Enter an ID consisting of between 1 and 16 numbers. 4 Press [OK]. A confirmation screen appears. (E.g.: Where the administrator ID is changed to 002) 5 Press [OK]. The new administrator ID is confirmed. 6 Press [MENU]. The display returns to Ready. 2-82 Using the Operation Panel