Kyocera KM-2030 Printing System (K) Instruction Handbook (Setup Edition) - Page 67

1. Printer Settings (15 ppm copier) Menu number Item Available settings P47 Wide A4 ON/OFF Increases the printing area on A4 size paper. (1) On (2) Off P48 Printing orientation (parallel interface) (1) Portrait (2) Landscape P49 Printing orientation (network interface) (1) Portrait (2) Landscape P50 Smoothing ON/OFF (1) On Allows a printing resolution of an interpolated 2400 (2) Off dpi x 600 dpi through the smoothing process. P51 EcoPrint ON/OFF (1) On Allows printing in a toner-saving mode. This mode is (2) Off especially suited for test pages, etc., where high printing quality is not required. P52 Printing resolution (1) 300 dpi (2) 600 dpi P55 RAM disk ON/OFF (1) On (2) Off P56 RAM disk size 01 - 99 (MBytes) Sets the amount of memory that will be used as a RAM disk. The maximum size that can be selected is the total amount of memory installed minus the amount used by the system (9 MB). P61 A4 & Letter usage ON/OFF (1) On Allows both A4 and letter size paper to be utilized as (2) Off though they are the same size. P62 Bypass mode If "First" (setting: 2) is selected here and there is paper set in the Multi-Bypass, paper feed will be accomplished from the Multi-Bypass. (1) Cassette (2) First P70 Force-print time-out 000 - 495 (sec.) If "000" seconds is selected here, successive pages will not be printed until they are manually force- printed (by pressing the Start key in the printer mode). Remarks Available only when the Network Card is installed. At least 16 MB of additional memory (option) must be installed. 1-5