Kyocera KM-2030 Printing System (K) Instruction Handbook (Setup Edition) - Page 80

2. Printer Settings (20 ppm copier) Item No. Item Display message Available settings 55 Receive dump mode Print HEX-DUMP OK The data that the printer receives for debugging programs and files is turned into hexadecimal code and printed out. If "OK" is selected here, this receive dump mode will be activated. The receive dump mode will be canceled under the following circumstances: • Form feed is initiated (by selecting the "GO" command in the printer mode and then pressing the Enter key). • A force-print time-out occurs. 56 Printer reset Printer Reset OK Resets the Printer Board only even without turning the power to the machine OFF. Remarks 57 Resource protect mode Resource pro. Protects the resource data of fonts and macros downloaded through PCL6 and, even if the emulation protocol is switched, the PCL resource will be saved in the printer's memory. If "Permanent" is selected here, temporary resources will not be saved. If, however, "Per/Temp" is selected, temporary resources will also be saved. Off, Permanent, Per/Temp At least 16 MB of additional memory (option) must be installed. 58 Auto Continue ON/OFF Auto Continue If one of the following error messages appears and "On" has been selected here, the error state will be released and the printing operation will be restarted automatically after a specified amount of time. "Memory overflow" "Print overrun" On, Off 59 Recovery time for Auto Continue Change # Sets the amount of time before Auto Continue engages when "On" is selected under the "Auto Continue ON/OFF" setting (item No.: 58). If "000" seconds is selected here, Auto Continue will engage immediately after the error. 000 - 495 (sec.) 60 Service Rep Status Page print out Prints out a Status Page for use by your service representative. Print Status page No, Print Displayed only when "On" is selected under the "Auto Continue ON/OFF" setting (item No.: 58). 2-12