Lenovo NetVista Hardware Maintenance Manual (HMM) for NetVista 6832 and 6833 s - Page 81

NOTE: If you cannot access the hard disk drive or load a diskette from Drive A or load a CD from the CD-ROM drive, make sure that the Configuration/Setup Utility has the startup sequence set with diskette, CD ROM, and hard disk drives. 001 - START • Insert the diagnostics diskette into the diskette drive. • Power-off then power-on the system unit. 002 - DO ANY POST MESSAGES, ERROR CODES, BEEPS, OR SYMPTOMS OCCUR? (YES, READ AHEAD. NO, GO TO STEP 003) • Go to "Index of Symptoms, Messages, Error Codes, or Beeps" on page 32. • End. 003 • Select Utility from the menu. • Select and execute Tech Support Form from the menu to generate a system configuration report. • Compare the system configuration list with the actual devices installed in system. NOTE: If necessary, remove the cover and visually compare the devices installed in the system unit to those shown in the Tech Support Form. 004 - IF THE NUMBER OF DISKETTE, HARD DISK, OR CD-ROM DRIVE IS NOT CORRECT, READ AHEAD; OR GO TO STEP 005. • Check the cable installation of all disk drives.(See "System Board Jumpers and Connectors" on page 113) - Diskette drive should be connected to the system board connector FLOPPY. - IDE Primary Channel Master and Slave Drives in Configuration/Setup Utility should be connected to the system board connector PRIMARY. - IDE Secondary Channel Master and Slave Drives in Configuration/Setup Utility should be connected to the system board connector SECONDARY. Check Procedures 49