Lenovo ThinkStation P900 (English) User Guide - ThinkStation P900 (type 30A4 a - Page 98
Remove the computer cover. See Removing the computer cover
View all Lenovo ThinkStation P900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
6. Keep the connector on the storage drive on the right as shown. Then, flex the sides of the bracket and align the four pins 1 on the bottom of the bracket with the corresponding holes in the storage drive. Note: Do not touch the circuit board (if accessible) of the 2.5-inch storage drive. 1 Figure 18. Installing the storage drive into the bracket 7. Install the bracket with the new storage drive into the hard disk drive bay. See step 7 on page 82. What to do next: • To work with another piece of hardware, go to the appropriate section. • To complete the installation or replacement, go to "Completing the parts replacement" on page 125. Installing or replacing a 2.5-inch storage drive with a converter in a hard disk drive bay Attention: Do not open your computer or attempt any repair before reading and understanding the "Read this first: Important safety information" on page v. To install or replace a 2.5-inch storage drive with a 2.5-inch to 3.5-inch converter in a hard disk drive bay, do the following: 1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect all power cords from electrical outlets and disconnect all cables that are connected to the computer. 2. Remove the computer cover. See "Removing the computer cover" on page 77. 3. Locate the hard disk drive bay in which you want to install or replace a storage drive. See "Locating internal drives" on page 7. 4. Remove the storage drive bracket from the hard disk drive bay. See step 4 on page 79. 5. Depending on whether you are installing or replacing a storage drive, do one of the following: 86 ThinkStation P900 User Guide