Lexmark XC9235 User Guide - Page 43

Faxing 43 Faxing Setting up the printer to fax Notes: • The following connection methods are applicable only in some countries or regions. • During the initial printer setup, clear the fax function check box and any other function you plan to set up later, and then touch Continue. • The indicator light may blink red if the fax function is enabled and not fully set up. Warning-Potential Damage: Do not touch cables or the printer in the area shown while actively sending or receiving a fax. Setting up the fax function 1 From the home screen, touch Settings > Device > Preferences > Run Initial Setup. 2 Turn off the printer, wait for about 10 seconds, and then turn it back on. 3 From the Before You Begin screen, select Change the Settings and Continue with the Wizard. 4 From the Fax/Email Server Setup screen, enter the needed information. 5 Finish the setup. Setting up fax using a standard telephone line CAUTION-SHOCK HAZARD: To avoid the risk of electrical shock, do not set up this product or make any electrical or cabling connections, such as the power cord, fax feature, or telephone, during a lightning storm. CAUTION-SHOCK HAZARD: To avoid the risk of electrical shock, do not use the fax feature during a lightning storm. CAUTION-POTENTIAL INJURY: To reduce the risk of fire, use only a 26 AWG or larger telecommunications (RJ-11) cord when connecting this product to the public switched telephone network. For users in Australia, the cord must be approved by the Australian Communications and Media Authority.