Netgear XSM7224S XMS7224S CLI Manual - Page 247

Chapter 4 Routing Commands This chapter describes the routing commands available in the 7000 series CLI. The Routing Commands chapter contains the following sections: • "Address Resolution Protocol (ARP) Commands" on page 4-1 • "IP Routing Commands" on page 4-8 • "Virtual LAN Routing Commands" on page 4-20 • "DHCP and BOOTP Relay Commands" on page 4-21 • "IP Helper Commands" on page 4-24 • "ICMP Throttling Commands" on page 4-26 Warning: The commands in this chapter are in one of three functional groups: • Show commands display switch settings, statistics, and other information. • Configuration commands configure features and options of the switch. For every configuration command, there is a show command that displays the configuration setting. • Clear commands clear some or all of the settings to factory defaults. Address Resolution Protocol (ARP) Commands This section describes the commands you use to configure ARP and to view ARP information on the switch. ARP associates IP addresses with MAC addresses and stores the information as ARP entries in the ARP cache. arp This command creates an ARP entry. The value for is the IP address of a device on a subnet attached to an existing routing interface. is a unicast MAC address for that device. 4-1 v1.0, November 2010