Netgear XSM7224S XMS7224S CLI Manual - Page 27

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0 active Primary Management Unit fails. The switch priority defaults to the hardware management preference value 1. Switches that do not have the hardware capability to become the Primary Management Unit are not eligible for management. Default Format Mode enabled switch priority Global Config switch renumber This command changes the switch identifier for a switch in the stack. The is the current switch identifier on the switch whose identifier is to be changed. The is the updated value of the switch identifier. Upon execution, the switch will be configured with the configuration information for the new switch, if any. The old switch configuration information will be retained, however the old switch will be operationally unplugged. This command is executed on the Primary Management Unit. Note: If the management unit is renumbered, then the running configuration is no longer applied (i.e. the stack acts as if the configuration had been cleared) Format Mode switch renumber Global Config movemanagement This command moves the Primary Management Unit functionality from one switch to another. The is the switch identifier on the current Primary Management Unit. The is the switch identifier on the new Primary Management Unit. Upon execution, the entire stack (including all interfaces in the stack) is unconfigured and reconfigured with the configuration on the new Primary Management Unit. After the reload is complete, all stack management capability must be performed on the new Primary Management Unit. To preserve the current configuration across a stack move, execute the copy system:running-config Stacking Commands 2-3 v1.0, November 2010