Netgear XSM7224S XMS7224S CLI Manual - Page 315

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0 ip access-list rename This command changes the name of an IP Access Control List (ACL). The parameter is the names of an existing IP ACL. The parameter is a case-sensitive alphanumeric string from 1 to 31 characters uniquely identifying the IP access list. This command fails is an IP ACL by the name already exists. Format Mode ip access-list rename Global Config {deny | permit} (IP ACL) This command creates a new rule for the current IP access list. Each rule is appended to the list of configured rules for the list. Note: The 'no' form of this command is not supported, since the rules within an IP ACL cannot be deleted individually. Rather, the entire IP ACL must be deleted and respecified. Note: An implicit 'deny all' IP rule always terminates the access list. Note: For the XSM7224S, the mirror parameter allows the traffic matching this rule to be copied to the specified , while the redirect parameter allows the traffic matching this rule to be forwarded to the specified . The assign-queue and redirect parameters are only valid for a permit rule. A rule may either deny or permit traffic according to the specified classification fields. At a minimum, either the every keyword or the protocol, source address, and destination address values must be specified. The source and destination IP address fields may be specified using the keyword 'any' to indicate a match on any value in that field. The remaining command parameters are all optional, but the most frequently used parameters appear in the same relative order as shown in the command format. Quality of Service (QoS) Commands v1.0, November 2010 5-41