Netgear XSM7224S XMS7224S CLI Manual - Page 448

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0 no username snmpv3 authentication This command sets the authentication protocol to be used for the specified user to none. The is the user name for which the specified authentication protocol is used. Format Mode no username snmpv3 authentication Global Config username snmpv3 encryption This command specifies the encryption protocol used for the specified user. The valid encryption protocols are des or none. If you select des, you can specify the required key on the command line. The encryption key must be 8 to 64 characters long. If you select the des protocol but do not provide a key, the user is prompted for the key. When you use the des protocol, the login password is also used as the snmpv3 encryption password, so it must be a minimum of eight characters. If you select none, you do not need to provide a key. The value is the login user name associated with the specified encryption. You must enter the in the same case you used when you added the user. To see the case of the , enter the show users command. Default Format Mode no encryption username snmpv3 encryption {none | des[key]} Global Config no username snmpv3 encryption This command sets the encryption protocol to none. The is the login user name for which the specified encryption protocol will be used. Format Mode no username snmpv3 encryption Global Config Management Commands v1.0, November 2010 7-32