Netgear XSM7224S XMS7224S CLI Manual - Page 493

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0 Term Host Address Port TimeOut Priority Definition The IP address or hostname of the configured TACACS+ server. The configured TACACS+ server port number. The timeout in seconds for establishing a TCP connection. The preference order in which TACACS+ servers are contacted. If a server connection fails, the next highest priority server is contacted. Configuration Scripting Commands Configuration Scripting allows you to generate text-formatted script files representing the current configuration of a system. You can upload these configuration script files to a PC or UNIX system and edit them. Then, you can download the edited files to the system and apply the new configuration. You can apply configuration scripts to one or more switches with no or minor modifications. Use the show running-config command (see "show running-config" on page 6-15) to capture the running configuration into a script. Use the copy command (see "copy" on page 6-31) to transfer the configuration script to or from the switch. You should use scripts on systems with default configuration; however, you are not prevented from applying scripts on systems with non-default configurations. Scripts must conform to the following rules: • Script files are not distributed across the stack, and only live in the unit that is the master unit at the time of the file download. • The file extension must be ".scr". • A maximum of ten scripts are allowed on the switch. • The combined size of all script files on the switch shall not exceed 2048 KB. • The maximum number of configuration file command lines is 2000. You can type single-line annotations at the command prompt to use when you write test or configuration scripts to improve script readability. The exclamation point (!) character flags the beginning of a comment. The comment flag character can begin a word anywhere on the command line, and all input following this character is ignored. Any command line that begins with the "!" character is recognized as a comment line and ignored by the parser. The following lines show an example of a script: ! Script file for displaying management access Management Commands v1.0, November 2010 7-77