Netgear XSM7224S XMS7224S CLI Manual - Page 469

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0 snmp-server enable traps stpmode This command enables the sending of new root traps and topology change notification traps. Default Format Mode enabled snmp-server enable traps stpmode Global Config no snmp-server enable traps stpmode This command disables the sending of new root traps and topology change notification traps. Format Mode no snmp-server enable traps stpmode Global Config snmptrap This command adds an SNMP trap receiver. The maximum length of is 16 case-sensitive alphanumeric characters. The is the version of SNMP. The version parameter options are snmpv1 or snmpv2. The SNMP trap address can be set using both an IPv4 address format as well as an IPv6 global address format. The following shows an example of the CLI command. (Netgear Switch)# snmptrap mytrap ip6addr 3099::2 Note: The parameter does not need to be unique, however; the and pair must be unique. Multiple entries can exist with the same , as long as they are associated with a different . The reverse scenario is also acceptable. The is the community name used when sending the trap to the receiver, but the is not directly associated with the SNMP Community Table, See "snmp-server community" on page39." Default Format Mode snmpv2 snmptrap {ipaddr | ip6addr } [snmpversion ] Global Config Management Commands v1.0, November 2010 7-53