Panasonic HDC HS9 Sd/hdd Video Camcorder - Multi Language - Page 41

Quick start This unit will resume recording/pause mode about 0.6 seconds after the LCD monitor is reopened. ≥ When in quick start standby mode about 60% of the power used in recording pause mode is being consumed, so the recording time will be reduced. 1 Select the menu. (l 29) [SETUP] # [QUICK START] # [ON] ≥ In the quick start mode, the zoom magnification becomes 1k and the picture size may differ from what it was before quick start standby mode. 2 Close the LCD monitor while the ≥ If [POWER SAVE] (l 30) is set to [5 MINUTES] and the unit automatically goes mode dial is set to or . into quick start standby mode, close the LCD monitor and then open it again. ≥ If the unit is exposed to vibration or shock, the time for the quick start mode to start may be slightly longer than 0.6 seconds. The status indicator A flashes green and the unit goes into quick start standby mode. ≥ The lens cover does not close. 3 Open the LCD monitor. The status indicator A lights red and the unit is put into recording pause approx. 0.6 seconds after it is turned on. ≥ Set [QUICK START] to [OFF] to cancel the quick start mode. ≥ Quick start standby mode is canceled if jabout 5 minutes has elapsed jmode dial is set to junit is turned off ≥ In the 24p digital cinema setting, the required time for the quick start operation is slightly longer than 0.6 seconds. ≥ In the quick start mode, it may take some time for automatic white balance to adjust, if the scene being recorded has a light source different from the scene last recorded. (When the MagicPix function is used, however, the white balance of the scene last recorded is retained.) 41 VQT1N74