Philips DVDR600VR User manual - Page 13

E9480UD_EN.qx3 05.1.8 4:15 PM Page 13 Hookups (cont'd) 13 Connecting to a TV Only TV has an S-Video In Jack 1 Connect your Antenna or Cable TV signal to the ANTENNA IN jack on the rear of the Recorder. 2 Connect an S-Video cable (not supplied) to the Recorder's S-VIDEO OUT jack and to the TV's S-VIDEO In jack. 3 Connect the supplied audio cable to the Recorder's white/red AUDIO OUT L/R (left/right) jacks and to the left/right AUDIO IN jacks on the TV. Match the cable colors to the jack colors. 4 Connect the supplied RF coaxial cable to the ANTENNA OUT jack on the rear of the Recorder. Connect the other end of the same RF coaxial cable to the Antenna In jack on your TV. Your TV's Antenna In jack may be labelled RF In,Antenna In, or 75 ohm. Check your TV's manual for details. 5 Connect the power cords of the Recorder and the TV to a power outlet. 6 Press STANDBY-ON y to turn on the Recorder. If "IS TV ON? C03" appears on the display panel, you need to turn on your TV and set it to the SVideo In channel. (See next step.) You cannot see the Initial Setup screens until you turn on the TV and have it on the correct S-Video In channel. 7 Turn on the TV power. Set the TV to the S-Video In channel. This is not channel 3 or 4 when you are using S-Video. Your TV remote may have a button or switch that selects the S-Video In channel. Or, go to your lowest TV channel and change channels down until you see the DVD background picture or Initial Setup screen on the TV. The Initial Setup screen will appear the first time you turn on the Recorder. Go to page 18 to continue. Helpful Hint • On the TV, the S-Video In jack may be labeled Y/C, S-Video, or S-VHS (super video).