Pioneer AVIC-F90BT Owner's Manual - Page 105

Using the HD Radio (Digital Radio) Chapter 19 Using the HD Radio (Digital Radio) 2 Switching the seek mode = For details, refer to this page. 3 Tuning in strong signals = For details, refer to this page. 4 Switching the reception mode = For details, refer to this page. Storing the strongest broadcast frequencies "BSM" (best stations memory) lets you automatically store the six strongest broadcast frequencies under the preset tuning keys [P1] to [P6] and, once stored there, you can tune in to these frequencies with the touch of a key. % Touch [Start] to turn BSM on. BSM begins to flash. While BSM is flashing, the six strongest broadcast frequencies will be stored under the preset tuning keys [P1] to [P6] in order of their signal strength. When this is complete, BSM stops flashing. p To cancel the storage process, touch [Stop]. p Storing broadcast frequencies with BSM may replace broadcast frequencies you have already saved by using [P1] to [P6]. Switching the seek mode You can select the method of seek tuning. % Touch [Seek] to select the desired setting. ! [All]: Seeks stations from both analog and digital broadcasting. ! [HD]: Seeks from digital broadcasting only. p If you select "HD" on this setting while [Blending] is set to "Analog", the setting on [Blending] turns to "Digital-Analog auto" automatically. Tuning in strong signals Local seek tuning allows you to tune in only those radio stations with sufficiently strong signals for good reception. 1 Touch [On] to turn local seek tuning on. To turn local seek tuning off, touch [Off]. 2 Touch [cPrev] or [Nextd] to set the sensitivity. There are four levels of sensitivity for FM and two levels for AM: FM: 1 - 2 - 3 - 4 AM: 1 - 2 p The FM "4" (AM "2") setting allows reception of only the strongest stations, while lower settings let you receive weaker stations. Switching the reception mode If a digital broadcast reception condition gets poor, the tuner automatically switches to the analog broadcast of the same frequency level in default. If you want to prevent a frequent automatic switching, switch this setting to [Analog]. % Touch [Blending] to switch the reception mode. ! [Analog]: Receives analog broadcasting only. ! [Digital-Analog auto]: Automatically switches to the analog broadcast of the same frequency level as the digital broadcast. p If you select "Analog" on this setting while [Seek] is set to "HD", the setting on [Seek] turns to "All" automatically. En 105