Pioneer AVIC N2 Owner's Manual - Page 104

Operating Your Navigation System with Voice Chapter 9 NAVI/AV Voice Help VOICE icon Current page When voice command is possible When voice command is not accepted ❒ If no voice icon is displayed, check to see whether the microphone is properly connected and turn the power on again. ➲ When you are used to voice operation features and no longer need Voice Help, you can turn it off ➞ Page 64 Scrolling through the Voice Help Menu Scroll through the remaining commands using or . You can also display the commands by saying the words "Next Page" (or "Previous Page"). ❒ If you want to listen to the message of the Navigation System, say "Repeat". ❒ If you want to return to the previous screen, say "Back". To cancel voice operation You can cancel voice operation features at any time by pressing the POS button on the Navigation System. After you cancel voice operation, the map is displayed. ❒ If the system fails to recognize the command you speak, touch VOICE icon or say "Next option" and other operable commands will be displayed. If you then touch VOICE icon within 3 seconds, yet more commands are shown. Repeat this until the command you want to use is shown. ❒ If there are too many items to list, "1/**" is displayed. 102 ❒ Depending on the operating state of the Navigation System, some commands displayed in Voice Help may be unavailable. ❒ If no command is made in the next 6 seconds, voice recognition is canceled and the Navigation System is on hold until the next operation. Touch VOICE icon to reactivate voice operation. Operating by only voice when the Navigation System is started Turning on "Auto Voice Recognition" in the Settings menu allows all settings to be implemented by voice from after the Navigation System is turned on and until the route is set (applies only if the route is not yet set). ❒ If you press the VOICE button on the steering remote control in CD-VC1 (sold separately) during operation, voice operation mode is canceled. Voice Commands Commands marked with an asterisk (*) cannot be used in memory navi mode. Common commands Next Page, Previous Page, Back, Next Option, Repeat Commands for display change Displaying the navigation screen: Display NAVIGATION Displaying the Audio screen: Display AV Available voice commands related to navigation You can say the following commands: ❒ Give the following verbal commands after switching to the navigation screen. Specifying your destination New Destination*, Address Book*, Return Home*, , ❒ For the Address Book, , and , only the commands displayed in Voice Help can be used.