Pioneer AVIC N2 Owner's Manual - Page 63
Checking the connections of, leads and installation positions, Setting the Vehicle Dynamics, Display - no power
UPC - 012562735191
View all Pioneer AVIC N2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
NAVI ❒ The Navigation System can automatically use its sensor memory based on the outer dimensions of the tires. Checking the connections of leads and installation positions Check that leads are properly connected between the navigation unit and the vehicle. Please also check whether they are connected in the correct positions. 1 Touch "Settings" in the Main menu, then touch "Hardware Info". 2 Touch "Connection Status". The Connection Status screen appears. (1) (2) (3) (4) (5) (6) (7) (1) Speed Pulse The Speed Pulse value detected by this unit is shown. "0" is shown while the vehicle is stationary. (2) GPS Antenna Indicates the connection status of the GPS antenna, the reception sensitivity, and from how many satellites the signal is received. If the signal is received correctly, "OK" is displayed. If reception is poor, "NOK" appears. (3) Installation Position The Installation position of the navigation unit is shown. If installed correctly, "OK" appears. Indicates whether the Installation position of the navigation unit is correct or not. When the navigation unit is installed with an extreme angle exceeding the limitation of the installing angle, "Incorrect angle" will be displayed. When the angle of the navigation unit has been changed, "Excessive vibration" will be displayed. (4) Parking Brake When the parking brake is applied, "On" is displayed. When the parking brake is released, "Off" is displayed. (5) Power Voltage The power supply (reference value) provided from the vehicle battery to this unit is shown. If the voltage does not fall within the range of 11 to 15V, check that power cable connection is correct. (6) Illumination When the headlights or small lamps of a vehicle are on, "On" is displayed. (If the orange/ white lead is not connected, "Off" appears.) (7) Back Signal When the gear lever is shifted to "R", the signal switches to "High" or "Low". (Which of these is displayed depends on the vehicle.) Setting the Vehicle Dynamics Display You can change the values displayed by the instruments on the left and right of the Vehicle Dynamics Display. Until the sensor's initial learning is complete, only the voltage and clock are available. 1 Switch to the Vehicle Dynamics Display. ➲ Changing the map display mode ➞ Page 29 2 Touch the left or right instrument. Touch keys are displayed. 3 Touch the items you want to display. You can select the following items. • Voltage Displays the power supply and voltage supplied from the battery to this system. • Acceleration: Acceleration in a forward direction is displayed. The + sign indicates acceleration while the - sign indicates deceleration. • Side Acceleration: Acceleration in a side direction such as when turning, is displayed. The + sign indicates a right turn, while the - sign indicates a left turn. Chapter 4 Editing the Navigation Utilities 61