Pioneer AVIC N2 Owner's Manual - Page 62

NAVI The background image starts changing. After (1) a short while, the new background image (2) appears. (3) 8 Touch "Done". (4) On this screen, you can select the following items: Select another Picture : This is selected when you want to change to another picture. Return to Step 5. Change to another background : Select if you want to successively change the Audio Operating screen backgrounds or the Navigation backgrounds. Return to step 3. ❒ When changing a picture starts, do not cut off the vehicle engine until the message informing the completion of changing a picture is indicated. ❒ When the Navigation System is reset, or the language setting is changed, the background picture may change back to the original picture. (There is also a possibility that the system will revert to the original picture for some other reason). If this happens, set the background picture again. Checking the Navigation Status The navigation status, including the driving status of a vehicle, positioning status by satellite, learning status of the 3D sensor, and cable connection status can be checked. Checking sensor learning status and driving status 1 Touch "Settings" in the Main menu, then touch "Hardware Info". 2 Touch "3D Calibration". The 3D Calibration screen appears. (6) (7) (5) (1) Distance Driving distance is indicated. (2) Speed Pulse Total number of speed pulses is indicated. (3) Learning Status Current driving mode is indicated. (4) Degree of learning Sensor learning situations of distance (Distance), right turn (Right Turn), left turn (Left Turn), and 3D detection (3D Detection) are indicated by the length of bars. ❒ When tires have been changed or chains fitted, turning on the Speed Pulse allows the system detects the fact that the tire diameter has changed, and automatically replaces the value for calculating distance. ❒ If the ND-PG1 is connected, the distance calculation value cannot be replaced automatically. (5) Speed Speed detected by this unit is indicated. (This indication may be different from the actual speed of your vehicle, so please do not use this instead of the speedometer of your vehicle.) (6) Acceleration or deceleration/Rotational speed Acceleration or deceleration velocity of your vehicle is indicated. Also, rotational speed when your vehicle turns to left or right is shown. (7) Inclination Degree of slope of the street is indicated. To clear values... If you want to delete the learned results stored in "Distance", "Speed Pulse" or "Learning Status", touch the relevant result, then touch "Clear". 60 Editing the Navigation Utilities Chapter 4