Ricoh 5100N Quick Installation Guide - Page 109
Programs supplied on CD, System requirements, Installing software
UPC - 026649028502
View all Ricoh 5100N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
2 Programs supplied on CD The CD-ROM supplied with your printer card provides you with: • SetIP: A utility program allowing you to select a network printer card and manually configure the addresses for use with the TCP/IP protocol. System requirements To install SetIP, the following are required: • Operating system: Windows 2000/XP/2003 • Computer/Processor: 133 MHz or faster Pentium-compatible processor • Memory: 256 MB (recommended) • Hard Disk space: 2 GB hard disk with 1.5 GB available hard- disk space • Internet Explorer 5.5 or later, or Mozilla 1.0 Installing software 1 Insert the supplied CD-ROM into your CD-ROM drive. The CD-ROM will automatically run. If it does not, click Start Æ Run, enter x:/cdsetup.exe (x represents your CD-ROM drive), and click OK. 2 Select the language you want. 3 Click Install SetIP. 4 Follow the onscreen instructions to complete installation. 5 Click Finish when installation is done. Uninstalling software You should remove the Network utilities if you are upgrading the software or if the installation fails. NOTE: Close all programs before uninstalling software. 1 Click Start Æ Programs Æ Network Utilities Æ SetIP Æ Uninstall SetIP. 2 Click OK to confirm uninstallation. 3 Click Finish when uninstallation is done. 2.1 Programs supplied on CD