Ricoh AP610N Setup Guide - Page 41
Match the controller board to
UPC - 026649023385
View all Ricoh AP610N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Attaching Memory Unit Type C 256MB (SDRAM Module) E Pull the handle, and then slide the controller board out. I Align the notch of the memory unit to the slot, and then push it down until it clicks. 3 ZKGX260E F Place the controller board on a flat surface. G The memory unit is installed in the slot shown in the illustration below. ZKGX130E J Match the controller board to the top and bottom rail using the "T" mark, and then slide it into the printer slowly until it stops. ZKDX021J H Remove the default memory unit before installing a new memory unit. Press down the levers on both sides to remove the default memory unit. ZKGX250E K Push the handle of the controller board until it clicks. AGN016S ZKGX380E 37
Attaching Memory Unit Type C 256MB (SDRAM Module)
37
3
E
Pull the handle, and then slide
the controller board out.
F
Place the controller board on a flat
surface.
G
The memory unit is installed in
the slot shown in the illustration
below.
H
Remove the default memory unit
before installing a new memory
unit. Press down the levers on
both sides to remove the default
memory unit.
I
Align the notch of the memory
unit to the slot, and then push it
down until it clicks.
J
Match the controller board to the
top and bottom rail using the “
T
”
mark, and then slide it into the
printer slowly until it stops.
K
Push the handle of the controller
board until it clicks.
ZKGX260E
ZKDX021J
AGN016S
ZKGX130E
ZKGX250E
ZKGX380E