Ricoh AP610N Setup Guide - Page 44
Pull out the handle of the control
UPC - 026649023385
View all Ricoh AP610N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Installing Options C If the duplex unit is attached, push down the lever on right side ( ) and pull out the duplex Unit until it stops ( ). E Pull out the handle of the control- ler board. 3 ZKGX370E ZKGX320E If the duplex unit is not attached, go to the following steps. D Remove the two screws holding the controller board in place. F Pull the handle, and then slide the controller board out. Note ❒ Use a coin or similar object if the screws do not turn easily. ❒ These screws are used again in fastening the controller board. ZKGX260E G Place the controller board on a flat surface. ZKGX280E 40
Installing Options
40
3
C
If the duplex unit is attached,
push down the lever on right side
(
) and pull out the duplex Unit
until it stops (
).
If the duplex unit is not attached,
go to the following steps.
D
Remove the two screws holding
the controller board in place.
Note
❒
Use a coin or similar object if the
screws do not turn easily.
❒
These screws are used again in
fastening the controller board.
E
Pull out the handle of the control-
ler board.
F
Pull the handle, and then slide
the controller board out.
G
Place the controller board on a flat
surface.
ZKGX320E
ZKGX280E
ZKGX370E
ZKGX260E