Ricoh IM C300F User Guide - Page 233
See Managing the Number of Printed Sheets Using the, Classification Code] to [Optional] in Web Image
View all Ricoh IM C300F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 233 highlights
When a Message Appears While Using the Printer Function Message Cause Solution and reference "Cannot access the Memory Storage Device." An SD card or USB flash memory device is unavailable for use. • Check that the external media is formatted in FAT16 or FAT32, and write protection is not enabled on the media. • Check that the external media is not corrupted or damaged. "Cannot store data The paper size is of this size." too large. Reduce the paper size of the document to send. The document to send cannot be stored at a custom size. "Classification Code is incorrect." A classification code is not specified. Consult the machine administrator for the classification code, and enter the code in [Classification Code] in [Detailed Settings] on the [Basic] tab [Modify] under [Job Type] in the printer driver. The document was printed in a printer driver that does not support the classification code. Request the machine administrator to change the setting of the classification code. Machine administrator: Change [Classification Code] to [Optional] in Web Image Monitor if necessary. See "Managing the Number of Printed Sheets Using the Classification Code", User Guide (Full Version). "Collate has been The sort function cancelled." was canceled. Turn off the power of the machine, wait for 10 seconds or more after confirming that the main power indicator is turned off, and then turn on the power. page 9 "Turning On and Off the Power" "Command Error" A problem occurred in the data because of the communication status or another reason. Check that the machine can communicate with the computer properly. A printer driver that does not support the machine was used. Use the printer driver for the machine. Obtain and install the latest version of the driver. The print command In the printer driver, specify [Edge Smoothing] on the did not complete [Others] tab [Special Settings]. correctly. 231