Ricoh IM C300F User Guide - Page 250
Manual Entry is, in [Scan Ratio]
View all Ricoh IM C300F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 250 highlights
9. Troubleshooting Message Cause Solution and reference "Memory storage device not detected. Insert the device." An SD card or USB flash memory device is not recognized properly. • Use an SD card with a maximum capacity of 32 GB or a USB flash memory that supports USB 2.0. • An SD card or USB flash memory may not be recognized in some situations such as if the media is inserted before the application starts. Insert the SD card or USB flash memory after the application has started. • Do not use an SD card or USB flash memory that is not secured or protected by a password. • Use media that is formatted for FAT16 or FAT32. • Try another SD card or USB flash memory. • Turn off the power of the machine, wait for 10 seconds or more after confirming that the main power indicator is turned off, and then turn on the power. "Not all of the image will be scanned. Check the ratio and then press [Start] again." The scaling factor Specify a smaller value in [Send Settings] specified in [Scan Ratio] [Scan Ratio]. is too large. The paper size specified in [Scan Ratio] [Specify Size] requires a reduction value smaller than 25%. Specify a paper size for which a reduction ratio greater than 25% is specified in [Send Settings] [Scan Ratio] [Specify Size]. "Programmed. Cannot program the destination(s) that is not programmed in the address book." A folder specified by Manual Entry is included among the programmed destinations. Register the destination in the address book of the machine, and then register it to a program. 248