Sharp AR-337 AR-287 , AR-337 , AR-407 Operation Manual - Page 34
Interrupting A Copy Run
View all Sharp AR-337 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
INTERRUPTING A COPY RUN INTERRUPT can be used to temporarily stop a long copy run so that another job can be run. q INTERRUPT will not function during duplex copying. q Duplex copying, tandem copying and the JOB BUILD function can not be selected during interrupt copying. q When an optional dual tray output unit (AR-TR1) is installed, interrupt copies are output to the second tray of the unit. 5 KEY OPERATOR If the second tray is not installed, output of copies to the second tray must be disabled. See page 27 of the KEY OPERATOR'S GUIDE. 2 CHAPTER MAKING COPIES Interrupting a copy run 3 6 INTERRUPT CLEAR C INTERRUPT CLE CA CLEAR ALL CA START 1 Press the INTERRUPT key. q When the document feeder is being used, the copier will stop after completing the copying of the originals which have been fed into the document feeder. The INTERRUPT indicator will blink until the copier becomes ready for interrupt copying. Then the INTERRUPT indicator will light up. The copier will return to the initial setting. q If the copier has been programmed in the auditing mode, the account number entry message will appear. Enter your account number using the 10-key pad. The number of copies of the interrupt copying will be accumulated against this account number. 2 When the copier stops, remove the original(s) and set the original(s) for interrupt copying in the document feeder tray or on the document glass. q The maximum number of originals for interrupt copying is restricted. 1-sided originals: 20 sheets (10 sheets for 8-1/2" x 14" and 11" x 17") 2-sided originals: 10 sheets (5 sheets for 8-1/2" x 14" and 11" x 17") 3 Select the desired available copier functions. 4 Press the START key. 3 INTERRUPT 6 2-20 CLE CA 5 When the interrupt copy run is complete, press the INTERRUPT key again to cancel the mode and remove the original(s) used for interrupt copying. q The copier will reset itself to the functions which were in use before the INTERRUPT key was first pressed. 6 Replace the original(s) for the interrupted job and press the START key to resume copying. q If scanning of originals has been already complete, the original need not be replaced.