TP-Link T2600G-18TSTL-SG3216 T2600G-28MPSUN V2 CLI Reference Guide Guide - Page 223

27.10 ip address-alloc Description The IP address-alloc command is used to enable the DHCP Client function or the BOOTP Protocol. When this function is enabled, the specified interface will obtain IP from DHCP Server or BOOTP server. To disable the IP obtaining function on the specified interface, please use the no ip address command. This command applies to the routed port, the port-channel interface and the VLAN interface. Syntax ip address-alloc { dhcp | bootp } no ip address Parameter dhcp -- Specify the Layer 3 interface to obtain IP address from the DHCP Server. bootp -- Specify the Layer 3 interface to obtain IP address from the BOOTP Server. Command Mode Interface Configuration Mode Privilege Requirement Only Admin, Operator and Power User level users have access to these commands. Example Enable the DHCP Client function on the Lay 3 routed port 1/0/1: T2600G-28TS(config)# interface gigabitEthernet 1/0/1 T2600G-28TS(config-if)# no switchport T2600G-28TS(config-if)# ip address-alloc dhcp Disable the IP address obtaining function on the VLAN interface 2: T2600G-28TS(config)# interface vlan 2 T2600G-28TS(config-if)# no ip address 202