TP-Link T2600G-18TSTL-SG3216 T2600G-28MPSUN V2 CLI Reference Guide Guide - Page 404

lldp topologychange -- a notification generated by the local device to sense the change in the topology that indicates a new remote device attached to a local port, or a remote device disconnected or moved from one port to another. loopback-detection -- Enable loopback-detection trap. It is sent when the switch detects loopback or loopback is cleared. storm-control -- Enable storm-control trap. It is sent when the multicast or broadcast rate exceeds the predefined value. spanning-tree -- Enable spanning-tree trap. It is sent when the port forwarding status changes or the port receives TCN packet or packet with TC fport-channel-. memory -- Enable memory trap. It is sent when memory usage exceeds 80%. Command Mode Global Configuration Mode Privilege Requirement Only Admin level users have access to these commands. Example Enable SNMP extended bandwidth-control trap for the switch: T2600G-28TS(config)# snmp-server traps bandwidth-control 41.11 snmp-server traps ddm Description The snmp-server traps ddm command is used to enable SNMP DDM traps. DDM function is used to monitor the status of the SFP modules inserted into the SFP ports on the switch. To disable the sending of SNMP DDM traps, use no snmp-server traps ddm command. Syntax snmp-server traps ddm [ temperature | voltage | bias_current | tx_power | rx_power ] no snmp-server traps ddm [ temperature | voltage | bias_current | tx_power | rx_power ] 383