TP-Link T2600G-18TSTL-SG3216 T2600G-28MPSUN V2 CLI Reference Guide Guide - Page 429

43.2sflow enable Description The sflow enable command is used to enable sFlow function. To disable the sFlow function, please use no sflow enable command. Syntax sflow enable no sflow enable Command Mode Global Configuration Mode Privilege Requirement Only Admin and Operator level users have access to these commands. User Guidelines A valid agent address should be assigned to the sFlow agent embedded in the switch before you enable the sFlow function. Example Enable sFlow function globally: T2600G-28TS(config)#sflow enable 43.3sflow collector collector-ID Description The sflow collector collector-ID command is used to configure the parameters about the sFlow collector. Syntax sflow collector collector-ID value { [descript descript ] | [ ip ip ] | [ port port ] | [ maxData maxData ] | [ timeout timeout ] } Parameter value -- The ID of the sFlow collector you desire to configure. The value ranges from 1 to 4. descript --Give a description to the sFlow collector, which contains 16 characters at most. ip --The IP address of the sFlow collector. The type of the IP address should be IPv4, for example 192.168.0.100. 408