TP-Link T2600G-18TSTL-SG3216 T2600G-28MPSUN V2 CLI Reference Guide Guide - Page 255

29.10 storm-control pps Note: T2600G-18TS doesn't support this command. Description The storm-control pps command is used to configure the storm control mode as pps(packets per second) on an interface. To disable the pps mode, please use no storm-control pps command. Syntax storm-control pps no storm-control pps Command Mode Interface Configuration Mode (interface gigabitEthernet / interface range gigabitEthernet / interface port-channel / interface range port-channel) Privilege Requirement Only Admin, Operator and Power User level users have access to these commands. User Guidelines This command should be used along with the storm-control command to enable the storm control function and specify the detailed parameters in pps mode. Example Set the storm control mode as pps on port 1/0/5: T2600G-28TS(config)# interface gigabitEthernet 1/0/5 T2600G-28TS(config-if)# storm-control pps 29.11 storm-control Description The storm-control command is used to enable the broadcast, multicast, or unicast strom control function and to set threshold levels on an interface. To disable the storm control function, please use no storm-control command. Syntax storm-control { broadcast | multicast | unicast } { kbps | ratio | pps } { rate } no storm-control { broadcast | multicast | unicast } 234