TP-Link T2600G-18TSTL-SG3216 T2600G-28MPSUN V2 CLI Reference Guide Guide - Page 338

threshold | window | notify -- The parameter that you want to return to the default configuration. Command Mode Interface Configuration Mode (interface gigabitEthernet / interface range gigabitEthernet) Privilege Requirement Only Admin and Operator level users have access to these commands. Example For error frame seconds event, configure the error threshold as 8 and the event detection interval as 30 seconds on Gigabit Ethernet port 5: T2600G-28TS(config)# interface gigabitEthernet 1/0/5 T2600G-28TS(config-if)# ethernet-oam link-monitor frame-seconds threshold 8 window 300 37.7ethernet-oam remote-failure Description The ethernet-oam remote-failure command is used to configure whether to notify the link faults or not. The link faults include dying gasp and critical event. To return to the default configurations, please use no ethernet-oam remote-failure command. Syntax ethernet-oam remote-failure { dying-gasp | critical-event } notify { disable | enable } no ethernet-oam remote-failure { dying-gasp | critical-event } notify Parameter dying-gasp -- Dying Gasp link event. Dying gasp means an unrecoverable fault, such as power failure, occurs. critical-event -- Critical Event. Critical-event means unspecified critical event occurs. notify --Enable/Disable the event notification. By default, it is enabled. 317