TP-Link T2600G-18TSTL-SG3216 T2600G-28MPSUN V2 CLI Reference Guide Guide - Page 274

T2600G-28TS(config)# no monitor session 1 destination interface gigabitEthernet 1/0/2 Delete the monitor session 1: T2600G-28TS(config)# no monitor session 1 31.2monitor session source interface Description The monitor session source interface command is used to configure the monitored port. To delete the corresponding monitored port, please use no monitor session source interface command. Syntax monitor session session_num source interface gigabitEthernet port-list mode no monitor session session_num source interface gigabitEthernet port-list mode Parameter session_num -- The monitor session number, can only be specified as 1. port-list -- List of monitored port. It is multi-optional. mode -- The monitor mode. There are three options: rx, tx and both. Rx (ingress monitoring mode), means the incoming packets received by the monitored port will be copied to the monitoring port. Tx (egress monitoring mode), indicates the outgoing packets sent by the monitored port will be copied to the monitoring port. Both (ingress and egress monitoring), presents the incoming packets received and the outgoing packets sent by the monitored port will both be copied to the monitoring port. Command Mode Global Configuration Mode Privilege Requirement Only Admin and Operator level users have access to these commands. User Guidelines 1. The monitoring port is corresponding to current interface configuration mode. 2. Monitored ports number is not limited, but it can't be the monitoring port at the same time. 253