TP-Link T2600G-18TSTL-SG3216 T2600G-28MPSUN V2 CLI Reference Guide Guide - Page 297

35.8access-list standard Description The access-list standard command is used to add Standard-IP ACL rule. To delete the corresponding rule, please use no access-list standard command. Standard-IP ACLs analyze and process data packets based on a series of match conditions, which can be the source IP addresses and destination IP addresses carried in the packets. Syntax access-list standard acl-id rule rule-id { deny | permit } [[ sip source-ip ] smask source-ip-mask] [[ dip destination-ip ] dmask destination-ip-mask ] [ tseg time-segment ] no access-list standard acl-id rule rule-id Parameter acl-id -- The desired Standard-IP ACL for configuration. rule-id -- The rule ID. deny -- The operation to discard packets. permit --The operation to forward packets. It is the default value. source-ip -- The source IP address contained in the rule. source-ip-mask -- The source IP address mask. It is required if you typed the source IP address. destination-ip -- The destination IP address contained in the rule. destination-ip-mask -- The destination IP address mask. It is required if you typed the destination IP address. time-segment -- The time-range for the rule to take effect. By default, it is not limited. Command Mode Global Configuration Mode Privilege Requirement Only Admin, Operator and Power User level users have access to these commands. Example Create a Standard-IP ACL whose ID is 520, and add Rule 10 for it. In the rule, the source IP address is 192.168.0.100, the source IP address mask is 276