Toshiba 55WX800U User Manual - Page 91

Chapter 10: Appendix Operating other devices Your TV remote control has one dedicated TV mode and five programmable multi-brand modes: CABLE/ SAT, BD, DVD, VCR/PVR and AUX. Note: To operate a non-Toshiba device or a Toshiba device that the remote control is not preprogrammed to operate, you must program the remote. Mode select TV CABLE/SAT BD DVD VCR/PVR AUX Default device mode control (before programming) Toshiba TV Toshiba Satellite receiver Toshiba BD player Toshiba DVD Toshiba VCR Onkyo Receiver Mode select TV CABLE/SAT BD DVD VCR/PVR AUX Device mode control (after programming) Toshiba TV Multi-brand video/audio devices Note: If you cannot program the TV's remote to operate your device or some of its features, use the device's remote or the controls on the device. Programming the remote to operate other devices Device code setup 1 Find the code for your device brand in the remote control device code table (- p. 94-99). If multiple codes are listed, try each one separately until you find one that works. 2 Press and hold a mode select button (CABLE/SAT, BD, DVD, VCR/PVR or AUX), until the button blinks 3 times. 3 While holding down , press the 5-digit code for your device. Result Meaning 2 blinks Valid code 1 long blink Invalid code 4 Point the remote at the device. Press to test the code. Result Meaning The device responds. Valid code The device does not respond. Invalid code Repeat the procedure, using another code 5 When programming is complete, test all necessary keys on the TV's remote that operate your device. If some keys are not operational, repeat the device code setup using another code (if other codes are listed for your device). 6 To control the TV, press TV. 7 If your VCR does not respond to the codes for your VCR brand, and has a switch labeled VCR1/VCR2, set the switch to the other position. Reprogram the remote control. Note: Every time you change the batteries, you must reprogram the remote. 91