Toshiba SD-V395 Service Manual - Page 36
: LOADING MOTOR/WORM Refer to Fig. 2-6-A, 7: TENSION ASS'Y Refer to Fig. 2-7-B, Refer to Fig. 2-7-C
View all Toshiba SD-V395 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
DISASSEMBLY INSTRUCTIONS 2-6: LOADING MOTOR/WORM (Refer to Fig. 2-6-A) 1. Remove the screw 1. 2. Remove the Loading Motor. 3. Remove the Worm. Main Chassis Loading Motor Worm 2-7: TENSION ASS'Y (Refer to Fig. 2-7-B) 1. Turn the Pinch Roller Cam clockwise so that the Tension Holder hook is set to the position of Fig. 2-7-A to move the Tension Arm Ass'y. 2. Remove the Tension Spring. 3. Unlock the 2 supports 1 and remove the Tension Band. 4. Unlock the support 2 and remove the Tension Arm Ass'y. 5. Unlock the support 3 and remove the Tension Connect. 6. Float the hook 4 and turn it clockwise then remove the Tension Holder. Tension Arm Ass'y • Screw Torque: 3 ± 0.5kgf•cm 1 Fig. 2-6-A NOTE 1. In case of the Worm installation, check if the value of the Fig. 2-6-B is correct. 2. In case of the Loading Motor installation, hook the wire on the Cassette Opener as shown Fig. 2-6-C. 3. When installing the wires between Capstan DD Unit and Loading Motor, connect them correctly as shown Fig. 26-D. 19.2 ± 0.1mm Tension Connect 1 1 3 Fig. 2-7-A Tension Band Tension Spring Tension Arm Ass'y Tension Holder 2 4 Safety surface for pressing of the insert. Fig. 2-6-B Loading Motor Fig. 2-7-B NOTE 1. In case of the Tension Band installation, note the direction of the installation. (Refer to Fig. 2-7-C) 2. In case of the Tension Band installation, install correctly as Fig. 2-7-D. 3. In case of the Tension Connect installation, install as the circled section of Fig. 2-7-E. Loading Motor - + Pink White Cassette Opener Fig. 2-6-C Capstan DD Unit L2 L1 Fig. 2-6-D B2-2 Tension Connect Tension Band Fig. 2-7-C