Toshiba SD-V395 Service Manual - Page 44
: FEED MOTOR Refer to Fig. 3-11-A, Remove the Motor Gear.
View all Toshiba SD-V395 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
DISASSEMBLY INSTRUCTIONS NOTE 1. In case of the Idler Arm installation, install as the circled 11 section of Fig. 3-10-B. 2. In case of the Idler Arm Spring installation, install as the circled section of Fig. 3-10-C. 3. In case of the Chassis Spring installation, install as the circled section of Fig. 3-10-D. Idler Arm Motor Gear Main Chassis Ass'y Main Chassis Ass'y Fig. 3-10-B Feed Motor • Screw Torque: 1 ± 0.5kgf•cm Fig. 3-11-A NOTE 1. In case of the Motor Gear installation, check if the value of the Fig. 3-11-B is correct. 2. When installing the Feed Motor, check if the cable is positioned as Fig. 3-11-C. Main Chassis Ass'y Idler Arm Spring Fig. 3-10-C Motor Gear Feed Motor 6.1 ± 0.1mm Safety surface for pressing of the insert. Main Chassis Ass'y Fig. 3-11-B Chassis Spring Main Chassis Ass'y 3-11: FEED MOTOR (Refer to Fig. 3-11-A) 1. Remove the 2 screws 1. 2. Remove the Feed Motor. 3. Remove the Motor Gear. Fig. 3-10-D Feed Motor Pass the cable between 2 pins. Fig. 3-11-C B3-4