Yamaha 01V96i Owner's Manual - Page 10

10 Control Surface & Rear Panel AD Input Section 1 3 4 5 6 7 1 2 3 4 5 A A A A A B B B B B INPUT (BAL) INSERT OUT IN (UNBAL) INSERT I/O INSERT I/O INSERT I/O INSERT I/O INSERT I/O PAD 20dB 20dB 20dB 20dB 20dB -16 -60 GAIN PEAK SIGNAL -16 -60 GAIN PEAK SIGNAL -16 -60 GAIN PEAK SIGNAL -16 -60 GAIN PEAK SIGNAL -16 -60 GAIN PEAK SIGNAL CH1-4 9 10 11 12 13 15 A A A A B B B B 14 16 INSERT I/O INSERT I/O INSERT I/O INSERT I/O CH15/16 2TR IN 20dB 20dB 20dB 20dB +4 GAIN -26 +4 GAIN -26 -16 -60 GAIN PEAK SIGNAL -16 -60 GAIN PEAK SIGNAL -16 -60 GAIN PEAK SIGNAL -16 -60 GAIN +4 GAIN -26 +4 GAIN -26 PEAK SIGNAL 13 PEAK SIGNAL 14 15 PEAK SIGNAL 16 2 8 1 INPUT connectors A/B INPUT A connectors are balanced XLR-3-31-type connectors that accept line-level and microphone signals. Each of the phantom [+48V] switches on the rear panel turns on or off the +48V phantom power feed to the corresponding input. INPUT B connectors are balanced TRS phone-type connectors that accept line-level and microphone signals. The nominal signal level of both types of connectors ranges from -60 dB to +4 dB. Phantom power is not supplied to these connectors. If you connect cables to INPUT A and INPUT B connectors of the same number, only the signal from INPUT B is effective. Male XLR plug 1 (ground) 3 (cold) 2 (hot) 1/4" TRS phone plug Tip (hot) Ring (cold) Sleeve (ground) 2 INPUT connectors 13-16 These balanced TRS phone-type connectors accept line-level signals. The nominal signal level ranges from -26 dB to +4 dB. INPUT 15 & 16 connectors are available only when the AD 15/16 button is turned off. 3 INSERT I/O connectors These unbalanced TRS phone-type connectors are used for channel insert ins and outs. Use a split cable to insert an external effects processor to AD input channels. Connect to INSERT jack To processor's input 1/4" phone plug Tip (send) Tip (send) Ring (return) Sleeve (ground) Sleeve (ground) 1/4" phone plug 1/4" phone plug Tip (return) Sleeve (ground) From processor's output 4 PAD switches These switches turn on or off the 20 dB pad (attenuator) for each AD Input. 5 GAIN controls These controls adjust input sensitivity for each AD Input. Input sensitivity is -16 dB to -60 dB when the Pad is off, and +4 dB to -40 dB when the Pad is on. 6 PEAK indicators These indicators light up when the input signal level is 3 dB below clipping. Adjust the Pad switch and GAIN control so that the indicator rarely lights up at signal peak. 7 SIGNAL indicators These indicators light up when the input signal level exceeds -34 dB. 8 AD15/16 selector This button selects AD Input Channel 15 and 16 signals. When the button is turned on (pushed in), the 2TR IN signals (page 17) are selected. When the button is turned off (raised), the INPUT 15 and 16 signals are selected. 01V96i-Owner's Manual