Yamaha 01V96i Owner's Manual - Page 50
V96i Editor, The 01V96i console is not recognized
View all Yamaha 01V96i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
50 Troubleshooting Signal level is low at a specific frequency Can't control the 01V96i console from 01V96i Editor The 01V96i console is not recognized by your DAW software Signals are not recorded on your DAW software ❍ Could the EQ gain be excessively low? ❍ Routing a signal through GEQ or an effect will delay it relative to other signals. If a signal is mixed with the same signal routed differently, a comb filter effect will decrease the level at specific frequencies. ❍ Refer to the 01V96i Editor installation guide on the website. ❍ Have you downloaded and installed the Yamaha Steinberg USB Driver? ❍ You must connect the 01V96i to the computer and power-on the 01V96i before you start up your DAW software. ❍ Check the driver settings and device settings of your DAW software. ❍ Are the input ports set appropriately on your DAW software? ❍ If you're using Cubase, are the VST connection settings appropriate? ❍ Is the signal you want to record being routed to one of USB1-16? 01V96i-Owner's Manual