Yamaha 01V96i Owner's Manual - Page 29

Connections and Setup Input and Output Patching 29 Input and Output Patching The 01V96i is designed to enable you to patch (assign) signals to Inputs and Outputs. This section explains how to view the signals patched to Inputs and Outputs and change the assignment. Tip: If the data from a connected instrument fails to be input, or if you are unable to monitor the signal at the desired output, check the I/O patching, as explained below: Patching Input Channels By default, the Input Channels are patched as follows: • INPUT connectors 1-16....Input Channels 1-16 • ADAT IN channels 1-8......Input Channels 17-24 • Slot channels 1-8 Input Channels 25-32 • Outputs 1-2 of Internal Effects Processor 1-4 .........ST IN Channels 1-4 Follow the steps below to view or change the patching. 1. Press the DISPLAY ACCESS [PATCH] but- ton repeatedly until the following page appears. 1 Inputs and Slot channels that are currently assigned to Input Channels are shown in the parameter boxes (1) beneath the channel numbers. The parameter indicators are explained below No assignment • AD1-AD16 INPUT connectors 1-16 • USB 1-USB 16.......... TO HOST USB port chan- nels 1-16 • ADAT1-ADAT8 ...... ADAT IN channels 1-8 • SL-01-SL-16 Slot channels 1-16 • FX1-1-FX1-2 Outputs 1-2 of Internal Effects Processor 1 • FX2-1-FX2-2 Outputs 1-2 of Internal Effects Processor 2 • FX3-1-FX3-2 Outputs 1-2 of Internal Effects Processor 3 • FX4-1-FX4-2 Outputs 1-2 of Internal Effects Processor 4 • 2TD-L/R 2TR IN DIGITAL L/R connectors Follow the steps below to view or change the patching. 2. Use the cursor buttons to move the cur- sor to a patch parameter (1) for which you want to change the assignment, and rotate the Parameter wheel or press the [INC]/[DEC] buttons to modify the patching. 3. Press [ENTER] to confirm the change. Tip: To restore the default patching, recall Input Patch memory #00. Patching Omni Outs By default, the output connectors are patched as follows: • OMNI OUT connectors 1-4 .... Aux Out 1-4 • ADAT OUT channels 1-8......... Bus Out 1-8 • Slot channels 1-8 Bus Out 1-8 • Slot channels 9-16 Bus Out 1-8 • 2TR DIGITAL connectors........ Stereo Out L & R Tip: • The STEREO OUT connectors always output the Stereo Bus signals. • The MONITOR OUT connectors output monitor sig- nals or the 2TR IN signals, depending on the Monitor Source selector setting. Follow the steps below to view or change the patching. 1. Press the DISPLAY ACCESS [PATCH] but- ton repeatedly until the following page appears. 1 01V96i-Owner's Manual