Yamaha 01V96i Owner's Manual - Page 36
Using the EQ Library, EQ Edit
![]() |
View all Yamaha 01V96i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
36 Tutorial • F (Frequency) This parameter control specifies the center frequency for cut/boost, with a setting range of 21.2 Hz to 20.0 kHz. • G (Gain) This parameter control specifies the cut/boost amount in the range of -18.0 dB to +18.0 dB. The LOW and HIGH GAIN controls function as filter on/off controls when Q is set to HPF and LPF respectively. You can also press the buttons ([HIGH], [HIGH-MID], [LOW-MID], [LOW]) in the SELECTED CHANNEL section to select the desired band and use the rotary controls ([Q], [FREQUENCY], [GAIN]) to directly edit the Q, F, and G parameters. Q HIGH HIGH-MID FREQUENCY LOW-MID GAIN LOW Tip: • Turn the Q parameter control for the LOW band clockwise all the way to set the LOW-band EQ to "L. SHELF" (low-shelving), and counter-clockwise all the way to set it to "HPF" (high-pass filter). • Turn the Q parameter control for the HIGH band clockwise all the way to set the HIGH-band EQ to "H. SHELF" (high-shelving), and counter-clockwise all the way to set it to "LPF" (low-pass filter). • By default, the LOW band is set to "L. SHELF," and the HIGH band is set to "H. SHELF." 6. In the same way, adjust the EQ for the other channels. Tip: The meters in the upper-right corner of the page indicate the post-EQ signal levels of the currently-selected Input Channel. If these meters reach the "OVER" position, lower the pre-EQ signal level using the ATT. parameter control located in the upper-left on the page. Using the EQ Library EQ settings can be recalled from the EQ library. EQ library memory numbers 1-40 contain preset EQ settings (programs) suitable for commonly-used instruments, allowing you to work efficiently. 1. Press the LAYER [1-16] button. Input Channel Layer 1-16 is now available for control from the channel strip section. 2. Press the [SEL] button for the Input Channel to which you want to apply EQ. 3. Press the [EQ] button, then the [F2] but- ton to display the EQ | EQ Library page. 4. Rotate the Parameter wheel to scroll the library title list, and select a program that you want to recall. The selected program appears inside the dotted box. 5. Move the cursor to the RECALL button located to the left of the library title list, then press [ENTER]. The selected program is recalled. 6. Press the [F1] button to display the EQ | EQ Edit page. Adjust the parameters as desired. 01V96i-Owner's Manual
![](/manual_guide/products/yamaha-01v96i-owners-manual-5217b5b/36.png)