Yamaha 01V96i Owner's Manual - Page 34
To route Input Channel signals via Buses
![]() |
View all Yamaha 01V96i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
34 Tutorial This section describes how to route signals by combining the above two routing methods. 1. Press the DISPLAY ACCESS [PAN/ROUT- ING] button repeatedly to display the Pan/Route | Rout1-16 page. This page enables you to select a Bus Out as the signal destination for each channel. 1 3. To route Input Channel signals via Buses 1-8 to your recorder or DAW, use the 1-8 buttons to specify a Bus Out as the destination for each Input Channel to which an instrument or mic is connected. In this example, Input Channels 1-4 are assigned to Buses 1 and 2, and Input Channels 5-8 are assigned to Buses 3 and 4. 23 This page contains the following buttons: 1 1-8 buttons These buttons route Input Channel signals to Buses 1-8. You can select multiple buttons. 2 S button This button routes Input Channel signals to the Stereo Bus. 3 D button This button routes Input Channel signals to the specified output connectors and channels directly. 2. Move the cursor to the S but- ton for the Input Channel to which the musical instrument or microphone is connected, then press [ENTER] to turn it off. By default, each Input Channel is routed to the Stereo Bus, which enables you to monitor the signals from the MONITOR OUT connectors and the PHONES jack. However during multitrack recording, or when monitoring the sound with the DAW's effects applied, you will usually want to monitor the signals returned from the recorder or DAW rather than the input signals themselves. To do so, you must turn off the S button so that the Input Channel signals will not be sent to the Stereo Bus. 4. Press the [PAN/ROUTING] button repeatedly to display the Pan/Route | Pan page. This page enables you to set the panpots for signals routed from the Input Channels to the Stereo Bus, and for signals routed from the Input Channels to the odd-even buses. 5. Move the cursor to the PAN parameter controls for the Input Channels that are assigned to the odd-even buses, then rotate the Parameter wheel or press the [INC]/[DEC] buttons to set the pan. Cursor on the PAN parameter control Tip: You can also use the [SEL] buttons to select Input Channels, and the SELECTED CHANNEL [PAN] control to adjust the pan setting. 6. To route Input Channel signals to Direct Outs, press the DISPLAY ACCESS [PATCH] button repeatedly until the Patch | Direct Out page appears. The Direct Out page enables you to specify the output connectors or channels to which each Input Channel is directly patched. 01V96i-Owner's Manual
![](/manual_guide/products/yamaha-01v96i-owners-manual-5217b5b/34.png)