Yamaha PM5000 Owner's Manual - Page 89

Appendix Mono Input Module Bottom stay Transformer Stereo Input Module R260 Transformer leads CN201 XK367 C113 R119 R119 C114 Shield Brown White White Red Red YAMAHA CN202 3 4 J6 1 5 J6 2 Red IN5 R106 R104 R105 C183 7 Remove (unplug) the existing small circuit board from the module, and replace it with the circuit board now soldered to the transformer leads. Next, neatly tie the transformer leads using the supplied cable tie, and cut off the excess tie. Mono input module Bottom stay Transformer Transformer 5 Pass the transformer leads through the square lead hole. Mono Input Module Replace this circuit board Tie the transformer leads with the cable tie Tie through the holes Cut Stereo Input Module Lead hole Stereo input module Replace these two circuit boards Tie the leads in the same way as shown above Lead hole 6 The transformer leads must now be soldered to the small circuit board included in the ITR5000 package. One circuit board is used for each transformer on stereo modules. The leads must be soldered to the circuit board as shown in the illustration below. 8 Make sure the transformer leads are completely contained within the module. That completes transformer installation. Be careful that the leads don't get caught on any part of the console when installing or later removing the module. 87