ZyXEL SBG3300-N Series User Guide - Page 232
L2TP VPN Screen
![]() |
View all ZyXEL SBG3300-N Series manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 232 highlights
Chapter 21 L2TP VPN 21.2 L2TP VPN Screen Click VPN > L2TP VPN to open the Setup screen. Use this screen to configure the Device's L2TP VPN settings. Figure 132 VPN > L2TP VPN > Setup The following table describes the fields in this screen. Table 102 VPN > L2TP VPN > Setup LABEL DESCRIPTION Enable Select the check box to enable the Device's L2TP VPN function. VPN Connection This is the WAN interface where L2TP VPN listens for a client connection request. It is configured in the Default_L2TPVPN IPSec VPN rule in the VPN > IPSec > IPSec Setup screen. See Chapter 19 on page 205 for information on IPSec VPN. IP Address Pool Enter the pool of IP addresses that the Device uses to assign to the L2TP VPN clients. Access Group (Optional) Authentication Method Keep Alive Timer Note: These addresses use a 24-bit netmask and should not conflict with any WAN, LAN, DMZ, WLAN, or PPTP VPN subnet even if they are not in use. Specify up to 2 LAN groups (subnets) which a L2TP VPN client is allowed to access. If none is specified, all LAN groups can be accessed. Enter the IP address and subnet mask for the LAN group(s). Select how the Device authenticates a remote user before allowing access to the L2TP VPN tunnel. The authentication method has the Device check a user's user name and password against the Device's local database, which is configured in the Maintenance > User Account screen. The Device sends a Hello message after waiting this long without receiving any traffic from the remote user. The Device disconnects the VPN tunnel if the remote user does not respond. 232 SBG3300-N Series User's Guide
![](/manual_guide/products/zyxel-sbg3300n-series-user-guide-222663b/232.png)