ZyXEL SBG3300-N Series User Guide - Page 52
Bridge Mode
![]() |
View all ZyXEL SBG3300-N Series manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Chapter 5 Broadband Table 7 Routing Mode (continued) LABEL DS-Lite Relay Server IP VLAN Active 802.1p DESCRIPTION Specify the transition router's IPv6 address. These fields appear when the Type is set to ADSL/VDSL over PTM. Select this option to add the VLAN tag (specified below) to the outgoing traffic through this connection. IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a MAC-layer frame that contains bits to define class of service. 802.1q QoS Egress Traffic Rate Limit MTU MTU Size Apply Cancel Select the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this connection. The greater the number, the higher the priority level. Type the VLAN ID number (from 1 to 4094) for traffic through this connection. Enter the rate limit for the connection. This is the maximum transmission rate allowed for traffic on this connection. Enter the MTU (Maximum Transfer Unit) size for this traffic. Click Apply to save your changes back to the Device. Click Cancel to exit this screen without saving. 5.2.1.2 Bridge Mode Click the Add new WAN Interface in the Network Setting > Broadband screen or the Edit icon next to the connection you want to configure. Select Bridge as the encapsulation mode. The screen varies depending on the interface type you select. If you select ADSL/VDSL over PTM as the interface type, the following screen appears. Figure 23 Bridge Mode (ADSL/VDSL over PTM) 52 SBG3300-N Series User's Guide
![](/manual_guide/products/zyxel-sbg3300n-series-user-guide-222663b/52.png)